Introduction

To bring all equipment used in competition by Martin Toft Madsen in line with the UCI regulations all of the equipment not already sold through other parties are available for the general public on this site.

International Compliance

None of the equipment listed on this site is in need of special compliance certificates.

Availability

The equipment on this page is designed and/or manufactured in Denmark and made to order and consequently lead time from order to delivery can sometimes be long.

Prices & Ordering

Prices and lead times will vary significantly depending on volumes required, so all enquires should be directed to Martin Toft Madsen at martintoft at gmail dot com, who will be happy to discuss your requirements and provide quotations.

Small Di2 Buttons (Pair)

Pair of small push-buttons that connect to Shimano Dura-Ace 9100 Di2 junction boxes. Shifts the rear gear (rear derailleur). One button shifts up and the other one down.

A pair of 3D-printed ABS arm rests with 3mm thick neoprene padding. These only fit the 3T Aduro aero handlebar in Low configuration and give a narrower elbow width than the standard arm rests allow.
CAUTION: Please be aware that while the screw holes might fit other aero handlebars they are not intended for use on other handlebars and so any use on anything other than the 3T Aduro handlebar in the Low configuration is strongly advised against since the ABS plastic requires support underneath!

A pair of 40 degree ski bend extensions cut at an angle at the upwards sloping end to give a smaller grip diameter. The insertion end is a standard 22mm diameter and so fits most standard aero handlebars. Be aware, however, that the far end does not fit standard end shifter plugs meant to be used for round end extensions.

56-tooth aerodynamic chain ring that fits the Rotor SRM powermeter and has alternating narrow and wide teeth to keep the chain from falling off, even without a front derailleur or chain catcher.